Posted on: April 26, 2020 Posted by: admin Comments: 0


The information in this manual is subject to change without notice. GV/SE, AutoMax, RPM, and Reliance are trademarks of Rockwell International. This instruction manual provides a functional description of the Power Units for Type GV with circuit diagram and Specifications (Chapter 2), Installation. Download Product Manuals GV/SE is a general purpose PWM inverter in accordance with GV/SE Safety Education Guide IM, -, PDF.

Author: Tojasho Dobar
Country: Honduras
Language: English (Spanish)
Genre: Photos
Published (Last): 9 August 2004
Pages: 434
PDF File Size: 18.72 Mb
ePub File Size: 14.29 Mb
ISBN: 905-2-58748-567-2
Downloads: 8428
Price: Free* [*Free Regsitration Required]
Uploader: Fezuru

The required mounting hardware is supplied with the filter.

Download Product Manuals | Reliance Electric Limited

Grounding The Drive Page 62 – Table 7. This manual also for: Enter text from picture: Comments to this Manuals Your Name.

Encoder Wiring Guidelines Only qualified electrical personnel familiar with the construction and operation of this equipment and the hazards involved should start and adjust it. Determining Wire Size Requirements Recommended Motor Lead Lengths Refer to section 5.


This manual is intended for qualified electrical personnel. UL Class J, V, time delay, or equivalent. Page 38 – Table 3.

If a fault occurs, the drive will coast-to-rest stop g3v000 a 2- or 3-digit fault code will flash on the display. Page 55 Page 56 maanual Figure 5. Chapter 2 About The Drive Chapter 9 Troubleshooting The Drive If a fault occurs, the drive will coast-to-rest stop and a 2- or 3-digit fault code will flash on the display.

Page 85 – Figure 9. Page 24 – Figure 2. Chapter 9 Troubleshooting The Drive Checking The Installation Operator Interface Module Connector Installing Transformers And Reactors optional EN Section Title Protection against electrical shock 6.

Page 16 – Figure 2. Page 86 – Figure 9. Page 4 Technical Specifications No other type of mounting is permitted.

Reliance Electric GV3000 Instructions Manual

No additional filter installation is required. Jumper Locations And Settings Page 31 Table 2. Chapter 3 Planning Before Installing Installing Output Contactors optional To reduce line disturbances and noise, motor lead length should not exceed 76 meters feet for any non-Reliance Electric motor or any non-inverter duty motor.


Note that HP drives may be supplied with an optional Bv3000 disconnect.

Reliance electric GV3000 Manuals

Stopping The Drive Chapter 1 Introduction Function Loss Response A signal must be present at terminal 20 for the drive to be able to start. Meeting Encoder Specifications fvc Regulation Only Page 71 Jumper J4 must also be set. Table of Contents Add to my manuals Add. The encoder connects to terminals 4 through 9 of the Regulator board terminal strip as shown in table fv3000.

Page 40 – Table 3. Page Screen pigtails are not permitted.


Leave a Comment