Posted on: August 3, 2020 Posted by: admin Comments: 0

E3FS OMRON PDF

Note: The B1 Module is an input module for E3FS Sensors. It is made specifically for the F3SX Safety Controller. The safety output turns OFF when light is. Connect up to 4 sets of E3ZS/E3FS per B1 Module for F3SX Safety Controller. Connect to a . Refer to the F3SX, and consult with your OMRON representative. Order Omron Automation and Safety E3FSB4 2M (E3FSB42M-ND) at DigiKey. Check stock and pricing, view product specifications, and order online.

Author: Megal Damuro
Country: Nicaragua
Language: English (Spanish)
Genre: Technology
Published (Last): 4 February 2016
Pages: 367
PDF File Size: 13.99 Mb
ePub File Size: 17.29 Mb
ISBN: 755-3-75564-832-4
Downloads: 72883
Price: Free* [*Free Regsitration Required]
Uploader: Faeshakar

Suitable for detecting human bodies in hazardous area.

For detailed information about the muting control unit, refer to the specification sheet EE Functioning and isolation is checked afterwards. Functioning, water tightness and electrical isolation is checked afterwards. Emitting OFF Sink current: Open or 0 to 2,5 V: Emitting ON Leakage current: Mode selection input Receiver Connection to Vcc: Ambient temperature [9] Operating: M5 x 32 mm Material: All units are in millimeters unless otherwise indicated Plastic housing Cable type: A load must not be shorted.

  DEJAN LUCIC VLADARI IZ SENKE PDF

Omron E3fs, Omron E3fs Suppliers and Manufacturers at

A load must not be used with current higher than the rating. Do not apply the reversed supplied voltage. Be sure to route the E3FS cable separated from highpotential power line or through an exclusive conduit. The E3FS is in accordance with the requirements of the safety related control system to category e3fd only when it is connected with a specified control unit.

E3FS Light Beam Sender & Receiver, 1 Beam, 10m Max Range

Read this manual and the control unit manual completely. Be sure the information provided is understood before attempting to operate the E3FS. Omton E3FSs must be sufficiently far from each other to avoid mutual interference. Regarding the calculation of the safety distance, obey the control unit manual and related standards, e.

EN when the E3FS is used as a safety device.

Omron E3FS-10DB4-M1-M (E3FS10DB4M1M)

Regarding the avoidance of malfunction caused by shiny surface, obey the control unit manual when the E3FS is used as a safety device. Use an opaque test piece with 11 mm in diameter and mm or greater in effective length to check the detection capability.

  ENCYKLOPEDIA PSYCHOLOGII SZEWCZUK PDF

Otherwise the sensor may explode, burn, or cause electric shock. The power supply must conform to regulatory requirements and standards, regarding EMC and electrical equipment E3FS must not be used in water.

If the load and E3FS are connected to independent power supplies respectively, be sure to turn ON the sensor before turning the load ON. To extend the cable, use a wire of 0.

However do not extend it more than 50m. Do not use the E3FS in explosive or flammable gas. Do not disassemble, repair, and modify the E3FS.

Do not exceed a torque of 2. Hold the connector cover to connect or disconnect the connector.

Omron E3FSLB-M1-M (E3FS10LBM1M) – Axdos AB | PLCSWEDEN | Automation Spare Parts

Secure the omdon cover by hand. Do not use any pliers. The proper tightening torque range should be checked according to connector specification. Be sure to tighten the connector securely.

Categories:

Leave a Comment